RAD12-2033 TOSHIBA 驱动器

RAD12-2033 If you want to know the information in floppy disk and CD-ROM, you must insert them into floppy disk drive and CD-ROM drive respectively, so that the computer can recognize and process the data information on them.

Both floppy disk drives and CD-ROM drives are located in the chassis, with their mouths exposed, ready to “eat” floppy disks and CD-ROMs.
As for the hard disk, because it is immovable, it is fixed in the drive, that is to say, the hard disk and the hard disk drive are integrated. Pay attention to the direction when inserting the floppy disk into the floppy disk drive. When inserting the 3.5-inch disk, the rotating shaft should face down and the metal sheet should face forward. When you hear the eject button “click” at the bottom of the drive port, it means that the floppy disk is inserted.
When RAD12-2033 is taken out, you should press the eject button first, the floppy disk will automatically eject a part, and then the floppy disk will be pulled out. Nowadays, fewer and fewer people use 5.2-inch disks, and 5.2-inch floppy disk drives are rarely installed on computers. It is worth noting that there is a small indicator light above or below the floppy disk drive. When the indicator light is on, it means that the computer is reading or writing the floppy disk in this drive. The indicator light of the hard disk drive is also located on the front panel of the main chassis. When the indicator light is on, it means that the computer is reading or writing the hard disk.
When the drive indicator light is on, you can’t take out the floppy disk in the corresponding drive or shut it down, otherwise the disk may be damaged.
RAD12-2033 A computer may have more than one soft and hard disk drive. How do you distinguish them? We take the method of naming the drive. The names of drives are all represented by a single English letter. A and B are used to represent floppy disk drives, C, D and E are used to represent hard disk drives, and optical disk drives are generally represented by the letter H. In this way, there is what we often call “A drive, B drive, C drive and D drive”. Each computer generally has only one CD drive, so it is often referred to as “CD drive” for short.
Function broadcast
The RAD12-2033 driver is located in the main controller in the whole control process->: Driver->: The middle joint of the MOTOR. Its main function is to receive the signal from the main control box (NC CARD), then process the signal and transfer it to the motor and SENSOR related to the motor, and feed back the working condition of the motor to the MAIN CONTROLLER.